Bone Spreading Kit
Bone Spreading Kit
The Bone Spreading Kit is a system used for the spreading of thin ridges for implant placement. This kit uses a series of spreading pins to slowly spread a ridge open after being cut with a bone saw. The kit allows for the delicate adjustment of ridge width with little risk of fracture. This makes the Bone Spreader kit and essential part of any implant practice.
Instructions for use (Spreaders)
Use the saw provided to cut across the ridge
If multiple implants are being placed, make apical relief cuts to ensure the ridge does not crack under load
Insert the spreading pins inside the incised ridge
If the spreader is too thick, use the chisel to widen the gap
Connect the spreading adaptor to the spreading pin and turn the knob clockwise to spread the pin
Spread the ridge evenly by spreading the pins equally in series
After the ridge is expanded to the ideal width, remove the spreading pins and place the fixtures
-
BONE EXPANDER KIT$290.00
-
IMPLANT Positioning KITSpecial Price $550.00 Regular Price $995.00
Summary
Bone Spreading Kit
This kit is used for the spreading of thin ridges for implant placement. This kit uses a series of spreading pins to slowly spread a ridge open after being cut with a bone saw. This kit makes bone spreading simple and predictable.
Instructions for use
- Using the saw provided cut the alveolar ridge ( shown in the image below)
- Insert the spreading pins in-between the incised ridge. If the spreader is too thick, use above chisel to widen the gap
- Connect the spreading adaptor to the spreading pin and turn clockwise
- Spread the ridge evenly by spreading the pins equally in series
- After the ridge is expanded to the ideal width, remove the spreading pins and place the fixture
- Place Grafting material inside of the ridge before closing the flap
Kit Includes
- (1) 4x4mm square ratchet wrench
- (1) 7.0mm Saw
- (1) 8.0mm Saw
- (3) Spreading pins
- (3) Spreading adapters
- (1) Spreading pin driver